dR<\/p>\n
UN<\/p>\n
THIRD LAG<\/p>\n
\u5443<\/p>\n
\/<\/p>\n
A HILLS<\/p>\n
STANDARD 5B: SATELLITE DISHES; TWO-STORY BUILDINGS<\/p>\n
ADOPTED NOVEMBER 2006, RESOLUTION 03-06-58<\/p>\n
REVISED APRIL 2007, RESOLUTION 03-07-32<\/p>\n
GENERAL REQUIREMENTS REVISED APRIL 2011, RESOLUTION 03-11-49<\/p>\n
REVISED NOVEMBER 2013, RESOLUTION 03-13-120<\/p>\n
GENERAL REQUIREMENTS REVISED JANUARY 2018, RESOLUTION 03-18-12<\/p>\n
REVISED JUNE 2018, RESOLUTION 03-18-87<\/p>\n
1.0<\/p>\n
GENERAL REQUIREMENTS<\/p>\n
SEE STANDARD 1: GENERAL REQUIREMENTS<\/p>\n
2.0<\/p>\n
APPLICATIONS<\/p>\n
21<\/p>\n
Any installation permitted in Mutual Common Area at two story<\/p>\n
buildings must follow all guidelines set forth by the following Mutual<\/p>\n
Alteration Standard.<\/p>\n
2.2<\/p>\n
Prior to<\/p>\n
installation of any satellite dish,<\/p>\n
a plan and the<\/p>\n
specifications of all proposed work and equipment must be<\/p>\n
submitted for approval as specified in Section 1.5. The submitted<\/p>\n
plan must indicate all work to be done, i.e., type of dish, size, a full<\/p>\n
description, it’s location on the building, anchoring, and method of<\/p>\n
sealing wall(s) and attachments. Site location will be contingent<\/p>\n
upon Mutual approval.<\/p>\n
23<\/p>\n
The Member<\/p>\n
\u5fc5\u9808<\/p>\n
indemnify the Mutual<\/p>\n
and assumes all<\/p>\n
responsibility for any damage including, but not limited to, roof or<\/p>\n
wall damage, or damage from moisture intrusion resulting from<\/p>\n
improper installation of the satellite dish.<\/p>\n
24<\/p>\n
No satellite dish will be permitted which may become hazardous to<\/p>\n
other residents or workmen due to its location or dimensions.<\/p>\n
2.5<\/p>\n
Any satellite dish must be made easily removable as required for<\/p>\n
performance of maintenance. In the event a satellite dish must be<\/p>\n
removed it must be the Mutual Member’s responsibility to remove<\/p>\n
and properly store the dish until such time that maintenance work<\/p>\n
has been completed. The cost of removal, storage and re-<\/p>\n
installation must be borne by the Mutual Member.<\/p>\n
2.6<\/p>\n
Any satellite dish installation must follow all guidelines set forth by<\/p>\n
\u9019<\/p>\n
Federal<\/p>\n
\u901a\u8a0a<\/p>\n
Commission’s<\/p>\n
Over-the-Air-<\/p>\n
Reception- Devices rule (OTARD).<\/p>\n
Standard 5B \u2014 Satellite Dishes: 2 Story Buildings<\/p>\n
Page 1 of 5
\n2.7<\/p>\n
Any installation violating these guidelines is subject to immediate<\/p>\n
removal at the sole cost of the Mutual Member, and restoration of<\/p>\n
any Mutual property, at the Member’s expense.<\/p>\n
2.8<\/p>\n
Should the proposed location of a satellite dish be in an area that is<\/p>\n
Common Area, the applicant is required to execute and submit to<\/p>\n
Third Laguna Hills Mutual, prior to installation of a dish, the<\/p>\n
\u201cAgreement Regarding Satellite Dish Installation on Common Area<\/p>\n
Property.\u201d<\/p>\n
2.9<\/p>\n
Should the proposed location of a satellite dish be in a location that<\/p>\n
is currently occupied by a functional solar panel, an alternate<\/p>\n
location will be designated by the Alteration Division.<\/p>\n
2.10 All satellite dish installations must be removed at the time of resale.<\/p>\n
3.0<\/p>\n
INSTALLATION GUIDELINES<\/p>\n
3.41<\/p>\n
Satellite dish installation is permitted on Exclusive Use Common<\/p>\n
Area, e.g. patios or balconies. Dish must stay within footprint of<\/p>\n
patio or perimeter of balcony railing.<\/p>\n
3.2<\/p>\n
Only one (1) satellite dish per manor is allowed.<\/p>\n
3.3<\/p>\n
Any satellite dish installed on Common Area must not exceed a<\/p>\n
diameter of 36\u201d, with the exception of manor types listed in<\/p>\n
paragraph 3.16 herein.<\/p>\n
3.4<\/p>\n
No coaxial cable must be larger than 2\u201d diameter.<\/p>\n
3.5<\/p>\n
Unless otherwise specified, coaxial cable must be encased in 2″,<\/p>\n
26 gauge steel wire mold fastened to the surface of the wall with %%\u201d<\/p>\n
mounting clips and anchors, specified for stucco, attached every<\/p>\n
four feet. Wire mold must be painted to match the surface to which<\/p>\n
it is attached prior to installation. Fasteners must be properly<\/p>\n
sealed to prevent moisture intrusion. Sealants must be specifically<\/p>\n
manufactured for the application for which it is used.<\/p>\n
3.6<\/p>\n
Drilling through a roof is prohibited.<\/p>\n
3.7<\/p>\n
Utilization of any GRF Broadband installation and\/or equipment is<\/p>\n
prohibited.<\/p>\n
3.8<\/p>\n
Mounting of a satellite dish to PVC, ABS, plumbing vent pipes is<\/p>\n
prohibited.<\/p>\n
3.9<\/p>\n
No satellite dish or any portion of a satellite dish and its related<\/p>\n
members must be attached to any built-up roofing on a flat roof.<\/p>\n
3.10<\/p>\n
Mounting a satellite dish on a chimney is prohibited.<\/p>\n
Standard 5B \u2014 Satellite Dishes: 2 Story Buildings<\/p>\n
Page 2 of 5
\n3.11<\/p>\n
No modifications to any fascia, rain gutter or plumbing vent must be<\/p>\n
permitted. A satellite dish installation must not obstruct a rain gutter<\/p>\n
or plumbing vent in any way.<\/p>\n
3.12<\/p>\n
Satellite dishes and installation materials must be grounded in<\/p>\n
accordance with the National Electric Code.<\/p>\n
3.13<\/p>\n
Buildings with flat roof and mansard roof<\/p>\n
(a)<\/p>\n
Place the satellite dish approximately 15 feet from the edge<\/p>\n
of the flat roof above the manor for which the service is<\/p>\n
being provided. At no time can the dish be mounted on the<\/p>\n
side of the building or to existing fascias.<\/p>\n
(b)<\/p>\n
For installation of a satellite dish onto a flat PVC cool roof,<\/p>\n
the member must install a 3\u2019 X 3\u2019 satellite dish pad provided<\/p>\n
by the Mutual’s roofing contractor at the expense of the<\/p>\n
Member.<\/p>\n
(c)<\/p>\n
Mount the satellite dish on a non-penetrating satellite dish<\/p>\n
roof-mount weighted down by a minimum of four, 8\u201d x 8\u201d x<\/p>\n
16\u201d cinderblocks (see Example 1 below).<\/p>\n
(d)<\/p>\n
Extend the coaxial cable from the dish, across the surface of<\/p>\n
the roof, to the mansard roof. Continue over the mansard<\/p>\n
roof and rain gutter, firmly and without slack, until the coaxial<\/p>\n
cable reaches the overhang. (Do not alter or damage the tile<\/p>\n
or rain gutter in any way.<\/p>\n
(e)<\/p>\n
Attach wire mold to the overhang, continue in a straight line<\/p>\n
to the wall of the building, and down vertically and<\/p>\n
horizontally, as required, to provide entry to the manor 24″<\/p>\n
from the floor. Encase the coaxial cable in the attached wire<\/p>\n
mold. Penetrate the wall to bring coaxial cable into the<\/p>\n
manor. (See 3.5)<\/p>\n
(0)<\/p>\n
Do not place wire mold within 18″ of balconies, balcony<\/p>\n
railings or balcony overhangs. Do not place wire mold across<\/p>\n
any part of an overhang vent or near, or on, windows. Do not<\/p>\n
alter or damage wall-mounted air conditioners.<\/p>\n
3.14<\/p>\n
Buildings with flat roof and parapet<\/p>\n
(a)<\/p>\n
Place the satellite dish on the flat roof approximately 15 feet<\/p>\n
from the parapet above the manor for which the service is<\/p>\n
being provided. At no time can the dish be mounted on the<\/p>\n
side of the building or to existing fascias.<\/p>\n
(b)<\/p>\n
For installation of a satellite dish onto a flat PVC cool roof,<\/p>\n
the member must install a 3\u00b0 X 3\u2019 satellite dish pad provided<\/p>\n
Standard 5B \u2014 Satellite Dishes: 2 Story Buildings<\/p>\n
Page 3 of 5
\nby the Mutual’s roofing contractor at the expense of the<\/p>\n
Member.<\/p>\n
(c)<\/p>\n
Mount the satellite dish on a non-penetrating satellite dish<\/p>\n
roof-mount weighted down by a minimum of four, 8\u201d x 8\u201d x<\/p>\n
16\u201d cinderblocks (see Example 1 below).<\/p>\n
(d)<\/p>\n
Extend the coaxial cable from the dish across the surface of<\/p>\n
the flat roof to the parapet. Continue the coaxial cable up the<\/p>\n
wall of the parapet, over the crown, and down until it is<\/p>\n
several inches below an existing wire- mold installation. (Do<\/p>\n
not attach the coaxial cable to the interior wall of the parapet<\/p>\n
with fasteners.) Attach new wire mold immediately below the<\/p>\n
existing wire mold installation and continue vertically and<\/p>\n
horizontally as required to reach the manor 24″ from the<\/p>\n
floor. Encase the coaxial cable in the attached wire mold.<\/p>\n
Penetrate the wall to bring coaxial cable into the manor.<\/p>\n
(See 3.5)<\/p>\n
(e)<\/p>\n
Do not use, alter or damage existing wire mold installation.<\/p>\n
3.15<\/p>\n
Seville<\/p>\n
(a)<\/p>\n
Place the satellite dish approximately 15 feet from the edge<\/p>\n
of the flat roof above the manor for which the service is<\/p>\n
being provided. At no time can the dish be mounted on the<\/p>\n
side of the building, existing fascia, or on roof beams.<\/p>\n
(b)<\/p>\n
For installation of a satellite dish onto a flat PVC cool roof,<\/p>\n
the member must install a 3\u2019 X 3\u2019 satellite dish pad provided<\/p>\n
by the Mutual’s roofing contractor at the expense of the<\/p>\n
Member.<\/p>\n
(c)<\/p>\n
Mount the satellite dish on a non-penetrating satellite dish<\/p>\n
roof-mount weighted down by a minimum of four, 8\u201d x 8\u201d x<\/p>\n
16\u201d concrete blocks (see Example 1 below).<\/p>\n
(d)<\/p>\n
Extend the coaxial cable from the dish across the surface of<\/p>\n
the roof to the fascia. Attach the coaxial cable to the inside of<\/p>\n
the fascia and continue down to a location that is directly in<\/p>\n
line above the room selected for installation of the jack.<\/p>\n
Attach the coaxial cable to the overhang and continue to the<\/p>\n
wall of the building. Attach wire mold to the wall, vertically, in<\/p>\n
a straight line down to provide entry to the manor 24″ from<\/p>\n
the floor. Encase the coaxial cable in the attached wire mold.<\/p>\n
Penetrate the wall to bring coaxial cable into the manor.<\/p>\n
(See 3.5)<\/p>\n
(e)<\/p>\n
Do not use, alter or damage existing wire mold installation.<\/p>\n
Do not alter or damage rain gutters.<\/p>\n
Standard 5B \u2014 Satellite Dishes: 2 Story Buildings<\/p>\n
Page 4 of 5
\n3.16<\/p>\n
Casa Milano, La Quinta and Villa Lugano series<\/p>\n
(a)<\/p>\n
Mounting of satellite dishes on buildings is permitted only<\/p>\n
upon approval of Permits and Inspections office of a detailed<\/p>\n
plan indicating all work to be done, i.e., size, location,<\/p>\n
description and specifications.<\/p>\n
(b)<\/p>\n
Satellite dish installation is permitted on Excusive Use<\/p>\n
Common Area, e.g., patios or balconies. Dish must stay<\/p>\n
within footprint of patio of perimeter of balcony railing.<\/p>\n
AN<\/p>\n
\/\/<\/p>\n
\/\/<\/p>\n
ANY<\/p>\n
ys pr<\/p>\n
XN\u201d<\/p>\n
Example 1: Non-Penetratina Satellite Dish Roof Mount<\/p>\n
Standard 5B \u2014 Satellite Dishes: 2 Story Buildings<\/p>\n
Page 5 of 5<\/p>","protected":false},"author":2,"featured_media":0,"template":"","document_category":[1075,1740],"document_type":[53],"class_list":["post-18050","document","type-document","status-publish","hentry","document_category-architectural-standards-operating-rules-third","document_category-third-architectural-standards-ma","document_type-other"],"acf":{"document":5458,"resolutions":null,"legacy_id":"","pdf_extracted_text":""},"yoast_head":"\n